v3.0

Major VersionM

by Petr Roupec

Backup OM component by Acronis

Written By: Dozuki System (and 2 other contributors)
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

Flags

0

  1. In this case MAC Mini connected to terminal bus is being used for data store. Here is a configuration example of share point.

    • In this case MAC Mini connected to terminal bus is being used for data store. Here is a configuration example of share point.

  2. Insert Acronis CD into drive and boot the computer and when selection screen appear select “Acronis True Image 2014”. You can use keyboard as a mouse by pressing key F10 - see note on right hand side of the screen. If not booted in 60 second coputer boots from hardisk.

    • Insert Acronis CD into drive and boot the computer and when selection screen appear select “Acronis True Image 2014”.

    • You can use keyboard as a mouse by pressing key F10 - see note on right hand side of the screen. If not booted in 60 second coputer boots from hardisk.

    • Acronis system preparation

    • Af ter selection screen is shown - it will take several minutes

    • NO PANIC!

  3. Enter to configuration menu as shown on picture Configure IP address of the network card connected to Terminal Bus.

    • Enter to configuration menu as shown on picture

    • Configure IP address of the network card connected to Terminal Bus.

    • The IP address must be in the same range as computer to which backup is made.

  4. Verify configuration of the IP address switch to command line by pressing CTRL+F2

    • Verify configuration of the IP address

    • switch to command line by pressing CTRL+F2

    • Type command ifconfig and check the IP address.

    • Use ping command to verify if computer to which backup is made is reachable.

    • Return to graphical interface by pressing CTRL+F1.

  5. “Crear copia de securidad discos y particiones...” Select disks and partitions to backup In this selection of partitions and disks to backup is possible

    • “Crear copia de securidad discos y particiones...”

    • Select disks and partitions to backup

    • In this selection of partitions and disks to backup is possible

    • Create new archive

    • Instruct Acronis to create new archive and press “Examinar” where backup backup will be stored

  6. Select computer on which backup will be located it takes some time to get network response When computer selected dialog for user name and password is shown.

    • Select computer on which backup will be located

    • it takes some time to get network response

    • When computer selected dialog for user name and password is shown.

    • Password verification. After pressing acceptar dialog indication successful connection to target computer is show. Now you have to press “Cancelar” to move ahead.

    • Folder selection

    • After previous step list of folders is being shown. Select folder for the backup and enter name of backup

    • i.e. host name of the computer of which backup is being made

    • Warning message is shown - you can safely ignore it

  7. All recovery tasks are listed here. Progress is being shown wait until completion

    • All recovery tasks are listed here.

    • Progress is being shown

    • wait until completion

    • By closing Acronis as shown computer is being directly rebooted.

    • Please remove CD prior to closing Acronis.

Conclusion

You are DONE! Computer is back in service.

Author

with 2 other contributors

Dozuki System

Member since: 09/24/2009

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 275